Peptide Protcols, Peptide Blends

CJC-1295 NO DAC + Ipamorelin Dosage Guide (10mg)

Posted on by

QuickStart Guide

This blend of CJC-1295 NO DAC + Ipamorelin pairs CJC-1295 (no DAC), a modified GHRH analogue, with Ipamorelin, a selective GH secretagogue. Together, they’re designed to support natural growth hormone release and downstream IGF-1 levels, often used in research for recovery, body composition, and sleep support. CJC-1295 (no DAC) drives a steady GH signal, while Ipamorelin adds a clean, targeted pulse without pushing cortisol.

  • Reconstitution: Add 3.0 mL bacteriostatic water → ~3.33 mg/mL total (≈1.67 mg/mL each)
  • Typical Daily Range: 100–300 mcg of each peptide, once daily (titrate up gradually)
  • Easy Measuring: At 3.33 mg/mL total → 1 unit (U-100) = 0.01 mL ≈ 33.3 mcg of each peptide
  • Storage:
    • Lyophilized: −20°C or colder
    • Reconstituted: 2–8°C (fridge)
    • Avoid repeated freeze–thaw cycles
Powerful CJC-1295 no DAC + IPAMORALIN Peptide Vials – Lean Muscle & Recovery Support Australia

⚙️ How This Works

CJC-1295 (no DAC) is a modified GHRH analogue that signals the pituitary to release growth hormone in a more natural, pulsatile pattern, with research showing steady increases in both GH and IGF-1 after subcutaneous use. Ipamorelin works differently, acting as a fast GH secretagogue that triggers a quick pulse, typically peaking around 40 minutes after dosing, with a shorter half-life of about 1.5–2.5 hours. A key advantage is that Ipamorelin is selective, boosting GH without significantly affecting cortisol, ACTH, or prolactin. When used together, they hit separate pathways, creating a more complete and synergistic GH release profile that mimics the body’s natural rhythm more closely.

 
 

🧪 Steps FOr reconstitution

  1. Draw 1.0 mL bacteriostatic water using a sterile syringe
  2. Inject slowly down the vial wall (don’t blast it, avoid foaming)
  3. Gently swirl or roll until fully dissolved (no shaking)
  4. Label with the date, store in the fridge at 2–8°C, keep out of light
  5. Use within 4 weeks after reconstitution

⚖️ BENIFITS & SIDE EFFECTS

Research suggests this combination can support sustained increases in GH and IGF-1 through more natural, pulsatile release patterns, with Ipamorelin offering a selective boost in growth hormone without significantly raising cortisol or ACTH. Preclinical data also shows CJC-1295 (no DAC) supporting normalized growth patterns in animal models with consistent dosing. It’s generally well tolerated, with possible mild and temporary effects like flushing, headaches, or injection-site irritation, while some individuals may also notice increased appetite, slight water retention, or tingling sensations.
 

💉 Dosing Protocol

  • Start: 100 mcg of each peptide daily, increase by ~50 mcg every 1–2 weeks as tolerated
  • Target: 200–300 mcg of each peptide daily by around Weeks 5–12
  • Frequency: Once per day (subcutaneous)
  • Cycle Length: Typically 8–12 weeks, with optional extension to ~16 weeks
  • Timing: Usually before bed or upon waking, rotate injection sites

📅 Standard Protocol

❄️ Storage (Keep It Potent)

  • Lyophilized: Store at −20°C or colder, dry and out of light — good for up to 24 months
  • Reconstituted: Keep in the fridge at 2–8°C, use within 4 weeks
  • Let vials come to room temp before opening to avoid condensation getting inside
 
 

⚠️ Key Considerations

Use a fresh sterile insulin syringe every time and dispose of it properly in a sharps container. Rotate injection sites (abdomen, thighs, upper arms) to avoid irritation and buildup. If your dose runs over 10 mg with a 1.0 mL mix, you’ll need multiple vials to hit the volume, and if total volume goes past 1.0 mL, split it into two injections at different sites for better absorption. Inject slowly and give it a few seconds before pulling out to make sure the full dose is delivered. Keep a simple log of dose, date, and injection sites so nothing drifts, and most important, titrate up gradually, don’t rush it or skip steps unless you want your gut to push back.

 
 

💉 How to Inject (SubQ Basics)

  • Wipe the vial stopper and injection site with alcohol and let it dry fully
  • Pinch a small skinfold and insert the needle at 45–90° into subcutaneous tissue
  • Don’t aspirate, just inject slow and steady
  • If volume goes over 1.0 mL, split into two injections at different sites (e.g. left/right abdomen)
  • Rotate sites each time (abdomen is go-to, but thighs and upper arms work too) to avoid irritation and buildup
  • After injecting, wait a few seconds before pulling out to make sure the full dose goes in
  • Dispose of syringes straight away in a proper sharps container
 
 

🏃‍♂️ Lifestyle Support (for best results)

For best results, pair it with a balanced, protein-forward diet that matches your energy needs, combine resistance training with regular cardio to support metabolic adaptation, prioritize high-quality sleep since growth hormone release is strongest during deep sleep, and keep stress under control to maintain proper hormonal balance and recovery.

 
 

⚠️ Research Use Disclaimer

This content is for educational and research awareness purposes only, not medical advice, diagnosis, or treatment.CJC-1295 NO DAC + Ipamorelin is an investigational compound and is not approved for clinical use. All information is drawn from published research and clinical trial data and is not intended to promote or guide off-label or human use.